Pullin Evolution Mains Pressure Stainless Steel Unvented Cylinder Hot Water Tank Mega Flow System Indirect PE-210L

0 item(s) in a bag Total: £0.00- Checkout

Home > Plumbing & Heating > Mega Flow Hi Pressure Hot water Cylinders

Price

Your Price:

£664.20

Choose Options & Quantity

Please Consult The Table Below

Quantity

Description

Pullin Evolution Mains Pressure Stainless Steel Unvented Cylinder Hot Water Tank Mega Flow System Indirect PE-210L Characteristics of Evolution Complete package incorporates safety and hot water controls. Saving on installation from simplified plumbing and electrical connections. No anode to maintain or replace. Fully factory tested for reliability. Fast recovery rates. 10 year parts Guarantee on cylinder. 2 year parts guarantee on expansion vessel. 2 year parts guarantee on element and all other controls. Characteristics of Unvented Mains pressure hot water for balanced supply to shower and mixers-no shower pump to consider. No cold feed cistern required. No head problems. Safe, economical, performance. No loft pipes to freeze up. Flexible sitting of cylinder installation. UK manufactured and Tested Pullin Evolution cylinders are manufactured in the UK in an ISO 9001:2000 factory with each unit being pressure tested to 15 bar to ensure maximum safety. All Pullin Evolution units have integrated thermostatic controls and thermal cut outs for both direct and indirect heating. A factory fitted temperature and pressure relief valve provides a further level of thermal safety. Installation and Connections In order to give easy access to the cylinder during installation all of the plumbing and lectrical connections are located at the front of the unit. In addition the electrical connections are made to an integrated wiring centre which allows for a neater and simpler installation. Plumbing connections are 22mm compression. Coil in Coil Technology-Indirect Units The Pullin Evolution heat exchanger has a ‘coil in coil’ design which allows for a fast re-heat when water is used. Situated at the base of the unit, the heat exchanger ensures nearly all of the water is heated. Cold Water Controls Each unit is fitted with a cold-water control set which Incorporates a pressure reducing valve and strainer, expansion relief valve and check valve. By incorporating three components into one installation time is reduced and the flow rate is improved across a range of inlet pressures. Guarantee Pullin Evolution units come with a 10-year parts guarantee for the cylinder and 2 years parts guarantee on the expansion vessel and all other valves and fittings. Selection Guide Property type Indirect model Direct model Bedsit 100I or 120I 100D or 120D 1 or 2 bed with 1 bath or shower 150I 150D or 170D 3 bed with 1 bath or shower 150I or 170I 170D or 210D 4 bed with 1 bath or shower 170I or 210I 210D or 250D 2 or 3 bed with 2 baths or shower 210I 210D or 250D 4 or 5 bed with 2 baths or shower 210I or 250I 250D or 300D 4 or 5 bed with 3 baths or shower 250I or 300I 300D Light commercial usage 250I or 300I 250D or 300D Note: All sizings calculated using BS6700, 60 ltr hot water per bath,60 ltr hot water per shower, 15 ltr hot water per sink, 7 ltr hot water per basin, This selection chart is for guidance only. Hot water requirements will vary dependent on bath size, usage patterns, etc. Technical Data and Diagram